User's Manual

UltraLine II – Draft 1
030-300459 Rev. A
7/12/05
030-300459 Rev. A 13 July 2005
User Guide
UltraLine II (Model 800015)
6. INSTALLING THE HARDWARE
6.1 Installation Requirements
To install your UltraLine II, you will need one of the following:
• A Network Interface Card (NIC) installed in your PC
• An IEEE 802.11b/g adapter
NOTE: Internet service provider subscriber software and connection requirements may vary. Consult your ISP for
installation instructions. If you are using this Modem with an ADSL device, Please wait until you have received
notification from your ISP that your DSL line has been activated before installing this Modem and the software.
6.2 Before you begin
Make sure your kit contains the following items:
• Westell® UltraLine II
• Power Supply
• RJ-45 Ethernet cable (straight-through) (yellow)
• SMA Antenna
• Westell CD-ROM containing User Guide in PDF format
• Quick Start Guide
6.3 Hardware Installations
WARNING: Westell recommends the use of a surge suppressor to protect equipment attached to the power
supply. Use only the power supply provided with your kit.
NOTE: An additional Ethernet cable may be required depending on the installation method you are using. Ethernet
cables can be purchased at your local computer hardware retailer.
6.3.1 Installation via Ethernet WAN Uplink
1. Connect the yellow Ethernet cable (provided with your kit) from the Ethernet jack marked WAN on the rear
panel of the UltraLine II to the Ethernet port on the attached ADSL device, and then power up the attached
ADSL device.
2. Connect the attached ADSL device to the ADSL-equipped jack on the wall. IMPORTANT: If the attached
ADSL device is a Modem, do not
use a DSL filter on this connection. You must use the phone cord that was
provided with your kit.
3. Connect an Ethernet cable from any one of the four Ethernet jacks marked ETHERNET on the rear panel of the
Modem to the Ethernet port on your computer. Repeat this step to connect up to three additional PCs to the
UltraLine II.