User's Manual

UltraLine II – Draft 1
030-300459 Rev. A
7/12/05
030-300459 Rev. A 37 July 2005
User Guide
UltraLine II (Model 800015)
15.2 Port Forwarding Configuration
The following screen will be displayed if you select Port Forwarding from the Configuration menu. Port
Forwarding enables you to set up the Modem’s port forwarding attributes for the services that you want to add to
your profile.
To set up port forwarding, select a service from the Service Name drop-down menu.
NOTE: You may add an unlimited numbers of services to your profile.
After you have selected a service name from the Service Name drop-down menu, the following Port Forwarding –
Add an Application Service screen will be displayed. Enter the appropriate IP address or machine name in the fields
provided and then click Add Service. Repeat these steps to add additional services to your profile.
Application Protocol The IP Protocol type that is assigned to this service.
Start Port The start port that is assigned to the service
End Port The end port that is assigned to the service
LAN Port The LAN port that is assigned to the service.
Direction The traffic direction assigned to the service.
IP Address The LAN IP address or the machine name assigned to your service
Dynamic Application Factory Default = Disabled
If Enabled (box is checked), this will only allow outgoing connections
from any local PC.
If Disabled, packets will be forwarded to the designated local PC.