User's Manual

UltraLine II – Draft 1
030-300459 Rev. A
7/12/05
030-300459 Rev. A 48 July 2005
User Guide
UltraLine II (Model 800015)
Alternate LAN - Private LAN2 Settings
Select DHCP Network Displays the DHCP Network that you have selected.
Enable DHCP Server Factory Default = Disable
Possible Responses:
If Enabled (box is checked), this will enable the Private LAN DHCP server and
allow IP address to be server from the DHCP Private LAN pool.
If Disabled (box is unchecked), this will disable the Private LAN DHCP server.
Modem’s Public IP Address The Modem’s public IP address
Subnet Mask The Subnet Mask, which determines what portion of an IP address is controlled
by the network and which portion is controlled by the host.
Address Range
DHCP Start Address Displays the first IP address that the Public LAN DHCP Server will provide.
The DHCP Start Address must be within the IP address and lower than the
DHCP End Address.
DHCP End Address Displays the last IP address that the Public LAN DHCP Server will provide.
The DHCP End Address must be within the IP address and higher than the
DHCP Start Address.
DHCP Lease Time Factory Default = 01:00:00:00
Displays the amount of time the provided addresses will be valid, after which
time the Public LAN DHCP client will usually re-submit a request.
Note: DHCP Lease Time is displayed in the format (day:hour:min:sec)*. This
value must be greater than 10 seconds. Seconds must be between 0 and 59,
minutes must be between 0 and 59, and hours must be between 0 and 23.
If the settings you have entered in the Private LAN2 Settings fields are incorrect, the following warnings messages
may be displayed via pop-up screens. If this occurs, check the Private LAN settings.
Warning Message Check Public LAN DHCP Settings
Start Address is not part of the Subnet Check the value in the DHCP Start Address field
End Address is not part of the Subnet Check the value in the DHCP End Address field
End Address is below the Start Address Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds Check the values in the DHCP Lease Time fields
Seconds must be between 0 and 59 Check the Seconds field at DHCP Lease Time
Minutes must be between 0 and 59 Check the Minutes field at DHCP Lease Time
Hours must be between 0 and 23 Check the Hours field at DHCP Lease Time
15.7.3.3 Private LAN3 – Multiple IP Address Passthrough
If you selected Private LAN3 from the Select DHCP Network drop-down menu, the following screen will be
displayed. Enter the appropriate values and click Save to save the settings.