User's Manual

UltraLine II – Draft 1
030-300459 Rev. A
7/12/05
030-300459 Rev. A 53 July 2005
User Guide
UltraLine II (Model 800015)
IMPORTANT: IP Passthough must be disabled (if it has been previously enabled) before you enable static NAT.
Refer to section 15.7.4.2 for instructions on disabling IP Passthrough.
15.7.5.1 Enabling Static NAT
To enable Static NAT, select an IP address or device name from the options listed in the Static NAT screen and then
click Enable.
NOTE: The actual IP addresses or device names may differ from the those displayed in the following screen.
If you clicked Enable, the following screen will be displayed, with Static NAT enabled for the IP address or device
name you selected.
15.7.5.2 Disabling Static NAT
To disable Static NAT, click Disable in the Static NAT screen. The following screen will be displayed.
15.7.6 Port Mapping
The following screen will be displayed if you select LAN > Port Mapping from the Configuration menu. This
screen enables you to assign the physical ports to software groups. Select the appropriate options from the drop-down
menus, and then click Save to save your settings.