User's Manual

UltraLine II – Draft 1
030-300459 Rev. A
7/12/05
030-300459 Rev. A 59 July 2005
User Guide
UltraLine II (Model 800015)
The following screen will be displayed if you select WAN > QOS from the Configuration menu. This screen
enables you to configure the QOS services for your Modem. If you change the settings in this screen, you must click
Save Config to save the settings.
CAUTION: Changing the parameters on this screen could cause severe disruption of your service. It is recommended
that you do not change any settings in this screen unless instructed by your service provider.
QOS
Enable QOS Services Factory Default = Enabled
If Enabled (box is checked) this function will be activated.
If Disabled, this function will be deactivated.
Class of Service This enables you to partition network traffic into multiple priority
levels or classes or service.
Peak Info Rate The maximum allow rate for this priority.
QOS Services Committed Info Rate The committed rate for this priority.
Max Queue Size The number of packets that can be queued for this priority.
15.9.3 VPN
The following screen will be displayed if you select WAN > VPN from the Configuration menu. This screen
enables you to configure the VPN services for your Modem. If you change the settings in this screen, you must click
Save Config to save the settings.