User's Manual

UltraLine II – Draft 1
030-300459 Rev. A
7/12/05
030-300459 Rev. A 60 July 2005
User Guide
UltraLine II (Model 800015)
15.9.4 Routing Table
The following settings will be displayed if you select WAN > Routing Table from the Configuration menu. To add
a route to the Network Routing Table, select the desired options from the drop-down menus, and then enter the
appropriate values in the fields provided. Next, click Add Route.
IP Interfaces
The list of active interfaces on the Modem, their IP addresses and subnet masks.
Address The IP interface address of the interface.
Subnet Mask The subnet mask of the interface.
Name The name assigned to the interface.
Possible Names are:
ppp0 – The WAN interface when the router is in PPP mode.
WAN– The WAN interface when the router is in Uplink Routed IP mode.
Private LAN – The main Ethernet interface.
Private LAN2 – The interface for Private LAN2 mode.
Private LAN3 – The interface for Private LAN3 mode.
Public LAN – The interface for Private LAN mode.
l0 – The local loopback interface.
Metric The numeric value assigned to this interface, used to calculate the best route to a destination
address.
Networking Routing Table
The list of the network routes. These can be either routes for directly connected networks, or static routes that have
been entered.
Destination The IP subnet of the destination network.
Subnet Mask The subnet mask of the destination network.
Gateway The IP address of the default gateway for this route.
Interface Indicates the name of the router’s interface to use for this route.
Metric The numeric value assigned to this route, used to calculate the best route to a destination
network.
Host Routing Table
The list of host routes. A host route is an IP route with a 32-bit mask.
Destination The IP address of the destination host.
Gateway The IP address of the default gateway for this route.
Interface Indicates the name of the router’s interface to use for this route.