User's Manual

UltraLine II – Draft 1
030-300459 Rev. A
7/12/05
030-300459 Rev. A 62 July 2005
User Guide
UltraLine II (Model 800015)
Wireless Basic Configuration
Wireless Operation Displays the current setting of the Modem’s wireless operation.
Factory Default = Enabled
When disabled, no wireless stations will be able to connect to the Modem.
Network Name (SSID) This string (32 characters or less) is the name associated with the Modem. To
connect to the Modem, the SSID on a Station card must match the SSID on the
Modem card or be set to “ANY.” (Note: If the SSID on a Modem is hidden, at the
station card you must manually type the SSID of the Modem to which you are
trying to connect.)
Channel The AP transmits and receives data on this channel. The number of channels to
choose from is pre-programmed into the AP card. The Modem transmits and
receives data on this channel. Station cards do not have to be set to the same
channel as the AP; the station cards scan all channels and look for the Modem
with the correct SSID.
Possible Responses:
1 through 11
Mode This setting allows station to communicate with the Modem.
Possible Responses:
Mixed: Station using any of the 802.11b, 802.11b+, and 802.11g rates can
communicate with the Modem.
Legacy Mixed: Same as Mixed, but also allows older 802.11b cards to
communicate with the Modem.
11b only: Communication with the Modem is limited to 802.11b
11g only: Communication with the Modem is limited to 802.11g
Frameburst Mode If enabled, additional algorithms are used for increased throughput.
If Disabled, this feature will not be activated.
Hide SSID If enabled, the Modem will not broadcast the SSID. To connect to the Modem,
each Station must configure its SSIDs so that it matches the Modem’s Network
Name (SSID).
If Disabled, this function will not be activated.