User's Manual

UltraLine II – Draft 1
030-300459 Rev. A
7/12/05
030-300459 Rev. A 72 July 2005
User Guide
UltraLine II (Model 800015)
The following screen will be displayed if you select Remote Access from the Maintenance menu. This screen
enables you to configure Remote Access on your Modem. Enter the appropriates values in the fields provided and
then click Save to save the settings.
Remote Access
User Name The name used for Remote Access session. The only valid characters are
(a-z, A-Z, 0-9). The User Name must be at least 6 characters and must
not exceed 12 characters long.
Password The password used for Remote Access session. Do not use spaces or
double-quotes in the password. The password must be at least 6
characters and must not exceed 12 characters long.
Confirm Password Enter the same values as the password.
Timeout The interval (in minutes) after which the Remote Access session will
disconnect, if it is idle.
Enable Timeout Factory Default = Enable
If Enabled (box is checked) this will activate the Remote Access timeout
function.
If Disabled, the Remote Access timeout function will be deactivated.
Enable Remote Access Factory Default = Disable
If Enabled (box is checked), Remote Access will be activated.
If Disabled, Remote Access will be deactivated.
Remote URL Displays the URL for the Remote Access session.
16.6 Statistics
16.6.1 Ethernet Port Statistics
The following settings will be displayed if you select Ethernet from the Statistics menu.
Ethernet Port Statistics
Interface Description The description of the Ethernet interface on the Modem.
In Errors The number of error packets received on the Ethernet interface.
In Discard Packets The number of discarded packets received.
In Unicast Packets The number of Unicast packets received on the Ethernet interface.
In Octets The number of bytes received on the Ethernet interface.
Out Errors The number of outbound packets that could not be transmitted due to errors.