Manualshelf

User's Manual Part 1

ManualsBrandsWestell ManualsElectronicsSpread Spectrum Transmitter
11121314151617181920
030-300419 Rev. A
Draft 8– 11/30/04
030-300419 Rev. A 11 November 2004
User Guide
Verizon One Telephone Subsystem
4. Test-fit the Verizon One Base Unit swivel stand on the screws and adjust the screw depth for a sliding fit. Once
the stand fits tightly against the wall, remove it from the wall.
5. Connect the included phone cable from the jack marked DSL on the rear panel of the Base Unit to the telephone
wall jack provisioned for DSL and phone service. This connection will provide dial tone for voice services in
addition to providing DSL to your Verizon One. (Note: The Verizon One has a convenience/Fax jack that can
be used to connect additional telephone equipment such as a fax machine).
6. Connect the AC 12V power supply cord to the power connector marked 12V AC on the rear panel of the
Verizon One Base Unit. Plug the other end of the power supply into an AC wall socket, and then turn on the
power switch (if it is not already on).
7. Check the Base to see if the Power LED is solid green. If the Power LED is solid green, the Verizon One Base
is powered up.
8. Verify telephone operation by pressing the <Speakerphone> button found on the front of the Base Unit. Once
pressed, the In-Use LED lights solid blue and a dial tone should be emitted from the speaker.
9. Once telephone operation has been verified, snap the Base Unit Swivel stand onto the base. Adjust the stand by
pressing the paddle and tilting the base until the top of the Base Unit Touches the edge of the circular stand.
The Base Unit must be installed in this position. Prior to placing the Base Unit and Swivel Stand onto the wall,
use the cable management grooves within the bottom of the stand to guide the Power, and telephone cables so
that the stand can sit flush with the wall. Mount the unit to the wall.
10. Once unit has been mounted to the wall, re-verify telephone operation by pressing the <Speakerphone> button
on the front of the Base Unit. Once pressed, the In-Use LED lights solid blue and a dial tone should be heard
from the speaker.