User's Manual Part 1

030-300419 Rev. A
Draft 8– 11/30/04
030-300419 Rev. A 17 November 2004
User Guide
Verizon One Telephone Subsystem
9. REGISTERING THE HANDSET TO THE VERIZON ONE BASE
Registration Procedure
After successfully charging your Verizon One Handset, you must perform a registration procedure to allow
the Handset to communicate with the base. To register the handset to the Base Unit perform the following
steps:
NOTE: To select soft key functions displayed on the left side of the LCD screen, press the
key in the top left
corner key of the Handset. To select soft key functions displayed on the right side of the screen, press the key
in the top right corner. These buttons are used to select soft key functions only. For example, if you want to select
Phonebook, press . To select Menu, press . To scroll up or down, use the round navigation button .
1. While at the Base Unit select the <Menu> function on the Handset.
2. Using the round navigational button, scroll down to find the [Registration] menu. Next, press the top left corner
key to select “Registration.”
3. After you have selected “Registration,” the Handset will instruct you to press and hold the <Intercom> key on
the Base Unit. Press and hold this key for 3 seconds.
4. After 3 seconds, the Handset will automatically register to the Base Unit.
To verify successful registration, press the <Talk/Flash> button on the Handset; a dial tone will be emitted
from the Handset and a call may successfully be placed. If no dial tone is emitted, but the Handset
indicated that it successfully registered with the base, verify that the Base Unit is connected to an active
telephone line and that this line is plugged into the “DSL” port on the back of the Base Unit.