User's Manual

-13-
Status Mode
The LTE700 repeater control software features three modes of operation, Status Mode, Control Mode and Management
mode. Selecting the Status Mode by clicking the Status button allows the user to review the system settings for seven main
categories.
The SYSTEM box displays Manufacturer, Repeater Type, S/W Version and current Temperature.
The ALARM section notifi es the user if alarm conditions exist for PLL LD, Isolation, Shut Down (DL/UL), DC Fail and Relay
Status. Green indicates a normal condition is present, if illuminated Red an alarm condition exists.
The LOCATION box will show the address information set by the user, if a new installation, it will be blank but can be popu-
lated by entering the Control Mode which will be covered later in this manual.
The box for Frequency shows the user start and stop frequencies for uplink and downlink.
Isolation value and enable status can be viewed in the box labeled ISOLATION.
Finally the Downlink and Uplink sections show Gain, Output(dBm), ALC Level(dBm) and HPA enable status for there respec-
tive links.