Installation manual

SPECIFICATIONS 558 .AND 55lC EN_G1NE.
SPECIFICATIONS
Engine Type Diesel, water cooled, four cycle, four cylinder,
in-line overhead valve type
Displacement 133 cubic Inches (2.179 liter)
Combustion Type In-direct injection
Combustion System Swirl chamber
Bore & Stroke 3.35 x 3.78 inches (85 x 96 mm)
Max. Angle of Installation Not to exceed 14'
Max. Angle of Rotation
Aring Order
Direction of Rotation
Propeller Shaft
Compression Ratio
Aspiration
Engine Speed
Fuel Consumption
Dimensions - inches (mm)
Engine Only
Weight
Air Flow
Not to exceed 3~' for 30 minutes
1-3-4-2
Counteltlockwise, when viewed from flywheel
Right hand direction of rotation
21:5:1
Naturally Aspirated
Idle speed: 950-1000 RPM
Cruising Speed: 2000-2500 RPM
No ~ad speed: 3200 RPM (neutral)
1.5 U.S. gph running at 2500 RPM (approx.)
when the propeller used allows the engine to
turn at 3000 RPM at full open throttle underway
in forward
Height: 23.3 inches
Width: 18.6 inches
Length: 27.0 inches
4481bs (203.2 kgs)
(592 mm)
(472 mm)
(687 mm)
Engine Combustion: 116 cfm (3.3 cmn)
Engine Cooling: 200 cfm (5.6cmm)
TUNE-UP SPECIFICATIONS
Compression Pressure
Valve liming
Intake Opens
Intake Closes
Injection liming
441 psi (3.04 MPa)
Open at 15' BTDC - Close 29' ABDC
Open at 40' BTDC - Close 16' ATDC
16' BTDC-55-B
8' BTDC-55-C
Nozzle Injector Pressure 1920 psi (13.2 MPa)
Valve Clearance 0.0157 inches (0.4 mm)
(engine cold)
ELECTRICAL SYSTEM
Starting Battery 12 Volt, (-) negative ground
Battery Capacity 600 - 800 CCA (min.)
DC Charging Alternator
Starting Aid
Starter
Cold Cranking Amps
Alternator Regulator
Exhaust Elbow
Exhaust Hose Size
Exhaust Gas Flow
Muffler Size min.)
50 Amp rated, belt-driven -12V
Glow plugs, 12V sheathed
12 Voh, 1.8 KW with solenoid
175 - 200 Amps
Internal regulator, built into alternator
EXHAUST SYSTEM
45' elbow
3.0" 1.0. hose
265 cfm at 3000 RPM
14" x t4"
General
Fuel
Fuel
Injection Pump
Injectors
Fuel Filter
Air cleaner
Fuel Lift Pump
General
Operating Temperature
Fresh Water Pump
Raw Water Pump
System Capacity
Sea Water Flow
at 3000 rpm
FUEL SYSTEM
Self bleeding
Diesel fuel #2 (catane rating of 45 or higher)_
BOSCH, PFR type
Throttle type
Primary, full flow, spin-on element
Replaceable paper cartridge.
Solid state wtth external filter
COOLING SYSTEM
Fresh water-cooled with tube and shell type
heat exchanger.
170-190' F (77 - 88' C)
Centrifugal metal impeller type belt-driven.
Positive displacement, rubber impeller,
belt-driven.
7.25 US qts (6.86 liters)
8.0 - 8.5 gpm (30.2 - 32.1Ipm)
(measured before discharging into water
injected exhaust elbow)
LUBRICATION SYSTEM
General
Oil Filter
Sump Capacity
(not Including filter)
Operating Oil Pressure
(engine hot)
Oil Grade
Oil Cooler
General
clutch
Forced lubrication by Trochoid type pump
Full flow spin-on
8 U.S. qts (7.6 liters)
43 - 85 psi (290 - 590 KPa)
API Specification CF or CG-4, SAE 30, 15W-30
Fresh water cooled
TRANSMISSION
ZF Marine Transmission, case hardened, helical
gears, with a servo-operated multiple disc
Gear Ratio (standard) 1 :88:1 (ZF25M)
Propeller Recommendations 18 x 13P-2blade (RH) or 18 x 11 P 3 blade (RH)
(Propeller used should allow the engine to
reach its full rated RPM (3000 + 000 -100) at
full open throttle while underway in forward
gear)
Lubricating Fluid
Transmission Sump
Capactty
Automatic transmission fluid, type Dexron II
or III
0.75 U.S. qts. (0.79 liters)
~ WESTERBEKE
Engines & Generators
49