Installation manual

SPECIFICATIONS 12.6 BTD, 11.5 BTD, 11.0 BTDB, 10.0 BTDA, 8.0 BTDA
Engine Type
Displacement
Aspiration
Combustion Chamber
Bore & Stroke
Firing Order
Direction of Rotation
Compression Ratio
Weight
Inclination
Engine Combustion Air
Requirements @60Hz
1800 rpm
GENERAL
Diesel, four-cycle, three-cylinder, fresh water-
cooled, vertical in-line overhead valve
mechanism.
80.4 cubic inches (1.318 liter)
Naturally aspirated.
Swirl type.
3.07 x 3.62 inches (78 x 92 mm)
1-3-2
Clockwise, when viewed from the front.
22:1
8.0 BTDA
10.0 BTDA
12.6 BTD
Continuous 15°
467 lbs (211.8 kilos)
513 lbs (232.7 kilos)
5131bs (232.7 kilos)
Temporary 25° (not to exceed 30 min.)
41 cfm (1.16 cmm)
TUNE-UP SPECIFICATIONS
Compression Pressure
Minimum
Spilled Timing (Static)
Valve Seat Angle
Engine Timing
Injector Pressure
Valve Seat Angle
Valve Clearance
(engine cold)
427 psi (30 kg/em') at 280 rpm
384 psi (27 kg/em')
17" (spill)
45°
17" BTDC
1991 + 71 - 0 psi (140 + 5 - 0 kgf/cm').
Intake 45°
Exhaust 30°
0.25mm (0.0098in)
LUBRICATION SYSTEM
General
Oil Filter
Sump Capacity
(not including filter)
Operating Oil Pressure
(engine hot)
Oil Grade
Pressure fed system.
Full flow, paper element, spin-on type.
3.9 U.S. qts (3.7 liters)
50- 60 psi (3.5- 4.2 kg/em')
API Specification CF, CG-4, C/-4, CJ-4,
SA£ 10W-40 or 15W-40.
General
Fuel
Fuel
Injection Pump
Nozzle
Fuel Filter
Air cleaner
Fuel Lift Pump
FUEL SYSTEM
Open flow, self priming.
No. 2-D (Cetane rating of 45 or higher).
SAE J313. Grade of diesel fuel according to
ASTM D975.
In-line plunger type (BOSCH).
Throttle type.
Cartridge Type
Replaceable paper filter cartridge.
12 volt DC lift capacity of 5' (1.5 mm) solid state
ELECTRICAL SYSTEM
Starting Battery
Battery Capacity
DC Charging Alternator
Starting Aid
Starter
General
Operating Temperature
Fresh Water Pump
Raw Water Pump
Raw Water Flow
at 1800 rpm.
(Measured before
discharging into
exhaust elbow).
System Capacity
(Fresh Water)
12 Volt, (-) negative ground
400 - 600 Cold Cranking Amps (CCA)
51 Amp rated, belt-driven
Glow plugs, sheathed type
12 Volt, reduction gear
COOLING SYSTEM
Fresh water-cooled block, thermostatically-
controlled with heat exchanger.
170-190° F (77- 88° C)
Centrifugal type, metal impeller, belt-driven.
Positive displacement, rubber impeller,
belt-driven.
7-8 gpm (25.9- 29.6 gpm).
5.0 US qts (4.7 liters)
Engines & Generators
47