Installation manual

SHORE POWER TRANSFER SWITCH CONNECTIONS
SHORE POWER CONNECTIONS (60 HERTZ)
Generator NOTE: Diagram shows connections '!''a two-
~ wire.120·Voltsystem. Forathree-wue system
~ t'----u-se dotted lines ror the other hot leg.
I
I ,.. .... -- ... ,
L-----!-G) ~~
' +--
r-----\<3> /
I , __ ..,
I
I
I
Ship-to- Shore Switch (3 Pole)
PN 32008
(40Amps/Pole)
PN 32009
(80Amps/ Pole)
PN 32010
(125 Amps/ Pole)
PN32133
(200.Ampa/Pole)
If the installer connects shore power to the vessel's AC cir-
cuit, this must be done by means of the Shore Power Transfer
Switch. Set
the transfer switch shown in the diagrams to the
OFF position. This switch prevents simultaneous connection
of shore power to generator output .
. A CAUTION: Damage to the generator can result if
utility shore power and generator output are conne.cted
. at the same time. This type of generator damage is not
covered under the warranty; it is the installer's respon-
sibility to make sure all AC connections are co"ect.
G
z
Ill
Ill
"'
"
N L1
)10
u
c
.J
ID
GENERATOR/SHORE
SWITCH
... - ...
/ '
'---'-ill• r;-u
I I
.....----7----..-,003 2J
.... _ ...
-- .....
/ '
L---~005 ~N
(NEUTRAL)! 7 @)
' .... _ .. /
_.N32009
PN32010
PN32'133
SHIP'S
LOAD
- SHIP'S
lL1 N)
.
SHORE POWER
230V 50HZ
SHORE
GROUND
-GROUND
50
120 VOLT/60HZ THREE WIRE CONFIGURATION
Notice the repositioning of the white wire ground load on the
terminal block to the generator case.
Generator
1
N G1~
NOTE: Diagram shows connections for a two-
wire,110·Volt system from the generator.
with three-wlre,120-Volt boat system.
Switching Shore Power to Generator Power
A CAUTION: Heavy motor leads should be shut off
before switching shore power to generator power or
vice-versa because voltage surges induced by switching
with heavy AC loads on the vessel being operated may
cause damage to the exciter circuit components in the
generator.