Installation manual

SPECIFICATIONS
WESTERBEKE 25 KW BEDA GENERATOR
ELECTRICAL SYSTEM AC GENERATOR (3 Phase)
Starting Battery
Battery Capacity
DC Charging Alternator
Starter
Starting Aid
DC No-Load Cu rrent
DC Cranking Current
12-Volt. (-) negative ground
400 - 600 Cold Cranking Amps (CCA)
51 Amp rated, belt-driven
12-Volt, Reduction Gear
Glow plugs, sheathed type
± 2% of rated Amps
250 - 300 Amps (engine cold)
General- 3 Phase
Brushless six pole, revolving field.
Sealed lubricated single bearing
design. 12 Lead reconnectable for low voltage
WYE and for Delta. Solid State voltage regula-
tor with protection circuitry.
Voltage - 3 Phase
Low voltage WYE 208 volts
(60 Hertz)
High voltage WYE 480 volts
DELTA 240 volts
Voltage - 3 Phase
High voltage WYE 380 volts
(50 Hertz)
DELTA 240 volts
AC GENERATOR (SINGLE PHASE)
Amperage - 3 Phase Low voltage WYE 86.7 Amps
(60 Hertz)
High voltage WYE 37.6 Amps
General- Single Phase
Voltage - Single Phase
Voltage regulation:
Frequency regulation:
Rating (Volts AC)
Brushless, four-pole, revolving field Sealed
lubricated single bearing design.
Reconnectable single phase for 120/240 volts
with solid state voltage regulator.
120 or 120/240 Volts - 60 Hertz
220 Volts - 50 Hertz
± 2% no load to full load.
.3 Hertz no load to tuilioad.
20 I<!N - 60 Hertz (1800 rpm)
120 Volts 208 Amps
120/240 Volts 208.109 Amps
20 I<!N - 50 Hertz (1500 rpm)
220 Volts 87 Amps
DELTA 75.2 Amps
Amperage - 3 Phase High voltage WYE 38.0 Amps
(50 Hertz)
DELTA 656 Amps
GENERATOR COOLING
Air Requirements
1.0 Power Factor 425 cfm (12.74 cmm)
(60 Hertz at 1800 RPM)
Note: Increase air supply 15% for 50 Hertz operation 1500 rpm
Engine Combustion Air 94.6 cfm (2.7 cmm)
Requirements
(60 Hertz at 1800 RPM)
"""" WESTERBEKE
Engines & Generators
46