Technical data

(d)Install the control rack.
(e) Install the pinion with its deep root tooth aligned
with an aligning mark on the rack.
(f) Install the spring upper seat and spring.
(g) Assemble the spring lower seat to the plunger.
Insert the Mark "L" area of the plunger collar into
the control rack side.
(h) Insert the tappet, using care not to drop the shim. Align the
tappet guide hole with the dowel pin hole of the housing
and insert the tappet guide pin. Install the lock plate before
installing the tappet guide pin and bend the lock plate after
inserting the pin.
(i) Install the smoke set stopper, return spring and washer. Then, insert
the split pin.
(j) Install the Angreich set plate and spring when equipped.
(4)Installation and Adjustment of Fuel Injection Pump
(a)When installing the pump assembly, select and install
the adjusting shim. After installing the pump, fit the tie
rod from the governor lever to the control rack. Install
the tie rod spring in place.
For proper 'selection of shim thickness, temporarily
install a shim having the same thickness as before
removal when installing the pump assembly. When
adjusting fuel injection timing, replace the current shim
with the proper one selected from nine kinds of shims,
thickness of them ranging from 0.2mm to 1.0mm at
intervals of 0.lmm.
(b)Install the tie rod cover.
(c)Connect the fuel feed line and fuel return hose.