Installation manual

GENERATOR SPECIFICATIONS
ENGINE SPECIFICATIONS
Engine Type
Bore & Stroke
Total Displacement
Bearings
Combustion Chamber
Compression Ratio
Filing Order
Aspiration
Direction of Rotation
Inclination
Governor
Fuel Pump
Fuel
Distributor
. Spark Plugs
Igniution Coil
Flame Arrester
Carburetor
3 cylinde~ 4 cycle, overhead camshaft
w/counterbalance shaft, carbureted water
cooled gasoline engine
2.56 x 2.61 inches (65.0 x 66.3 mm.
40.3 cubic inches (.66 liter)
Four main bearings
Semi-spherical
9.8 -1
1-3-2
Naturally aspirated
Counterclockwise viewed from the back end
25° continuous, all directions
30° temporary, aU directions
Mechanical
FUEL SYSTEM
Electric fuel pump
Unleaded 89 octane or higher gasoline
Breakerless distnbutor
14 mm
12vott
Metal screen type
Single-barrel downdraft type
General
Fresh Water Pump
Raw Water Pump
Cooling Water Capacity
Fresh water-cooled block through raw water-
coated heat exchanger circuit
Centlifugal type, metal impeller, belt-dnven
Positive displacement, rubber impeller,
belt dnven.
3.5 qts (3.4 liters)
LUBRICATING SYSTEM
Type
Oil Fitter
Oil Capacity
Oil Grade
Fon;ed lubocation by gear pump
Fuel flow, paper element, spin-on disposals
2.7 qts. (2.6 liters)
API Specification SJ class
AC GENERATOR (SINGLE PHASE)
Type
Ratings
4_SKW
3_8KW
7,DKW
Brush!ess, four pole capacitor,regulated.
1800 rpm/60Hz, 1500 rpm/50Hz
120/240 volts, 37.5118.7 amps, 60 Hz
single phase, 4 wire, 1.0 power factor
230 volts, 13 amps, 50 Hz, single phase,
4 wire, 1.0 power factor
120/240 volts, 58.3129.2 amps, 60 Hz,
single phase, 4 wire, 1.0 power factor
ELECTRICAL SYSTEM
S.DKW 230 volts, 21.7 amps, 50 Hz, Single phase,
4 wire, 1.0 power factor
Start Motor
Starting Battery
Battery Capacity
Battery Charging
12 volt reduction gear with solenoid
12 volt negative ground
TUNE-UP SPECIFICATIONS
150 Cold Cranking Amps(CCA)(min)
Integral electnc, 17 amps
Spark Plug Gap
Spark Plug Torque
Cylinder Head Torque
BoltTorque
"'" WESTERBEKE
Engines & Generators
49
0.031 ±.002 inches (0.8±0.05 mm)
10.8 -15.2Ib-ft
60 - 70 Nm 43 - 51 ft-Ibs
See TORQUING THE CYLINDER HEAD