Operator`s manual

POWER TAKE-OFF (PTO) ADAPTER KITS
The generator housing of the Generators is machined to accept an optional power take-off (PTO) adapter
kit. This kit allows the user to mount and to operate a hydraulic pump (or similar device) while the
generator is operating.
The operator is advised that the generator's drive engine produces a specific amount of horsepower at
1800 rpm. This horsepower can be ntilized either for generator AC amperage output or to operate the
PTO device. It cannot do both; that is, it cannot produce AC amperage and furnish horsepower to operate
the PTO device, simultaneously.
When mounting a PTO device using the optional adapter kit listed below, ensure good alignment of the
device to the spline coupling and ensure that if additional support is needed, it is added. When in doubt,
provide e"ira support.
CCHERAT :lR
HOUSXHC
P.LO. ADAPTER KIT
SPLINE COUPLIHC
AOAP"rER
CRPSCRCW (3)
LOCICW"::;"'En (:3)
lOTUD (41
I,.OCICWRSHER 14)
NUT C"')
BTO 8. 8KW KIT PM. 34786
8TO 10.9I(W. 1l.IH:W. AHD 12.Sk'W KIT PM. 37134
HVORAU1.IC PU~P
HVORECO
1122l.8A481R
' ......... _,,' .. '._ .. ,._... (PUMP SOURCE)
H ... DREca PUMPS
KALAMAZOO. HXCK.
(6l.6) :349-l.5.1.1
NOTE: Provisions should be made to prevent the PTO device from overloading the generator's engine.
Install a pressure relief valve on the hydraulic pump to limit maximum pumping pressure.
95 WESTERBEKE GENERATORS