Owner`s manual

COUPLINGS
1. Rigid Coupling Specify Bore Size
2. Drivesaver Flex Coupling 1" Thick Require (1)
rigid coupling (2A) & (2B) mounting screws
and bolts.
3. Flex Coupling (Deluxe) 2" Thick Specify Bore
Size (3A) Mounting capscrews, locks, and
nuts.
4. Set Screws To Lock Coupling To Shaft.
5. Point at which you check shaft coupling to
gear coupling.
See coupling alignment for
details.
To ground shaft to engine install jumper lead
from shaft coupling to engine or gear coupling
capscrews.
6. Transmission or Gear Coupling mounted on
engine. V-Drive is threaded and requires
capscrew
MM diameter.
7. Double check clearance between coupling nut
or bolt and bearing cover capscrew
on
transmission. Must not hit or it will cause
serious transmission failure. Rotate coupling
and shaft to check.
40
,-,
,-,
,=,
~_-f-..l-='- - - T
,
------t-
-------r-
I
FIGURE 13-C