User Manual Internal Desktop WD VelociRaptor ®
WD® Service and Support Should you encounter any problem, please give us an opportunity to address it before returning this product. Most technical support questions can be answered through our knowledge base or e-mail support service at http://support.wdc.com. If the answer is not available or, if you prefer, please contact WD at the best telephone number shown below. Your product includes 30 days of free telephone support during the warranty period.
Kit Contents Congratulations on purchasing a WD VelociRaptor! This document was designed to aid in the quick installation of your new SATA hard drive. If you experience problems following these procedures or need further information regarding the installation and use of your drive, visit our website at http://support.wdc.com to search our online knowledge base for frequently asked questions and other common troubleshooting tips.
2 Install the Hard Drive Figure 1 1. Slide the hard drive into an available 3.5-inch drive bay and secure the drive with the four mounting screws (two on each side). For proper grounding, install the screws in the hole positions (Figure 1). 2. Attach one end of the SATA cable to the SATA interface on the WD drive (Figure 2). SATA connectors are keyed to ensure proper insertion. 3. Connect the SATA power cable to the SATA interface on the drive (Figure 2). 4.
Partitioning/Formatting: 4 Alternate Instructions for Installing a Drive Note: In two separate windows, on the right side of the screen, a graphical representation of the partitions on the installed hard drives is displayed. The top window is for viewing a drive’s status, capacity, and file system. The bottom window displays a representation of the drives in the system beginning with the boot drive (drive 0). In almost all cases, you will want to work with the bottom window. 1.
Adding a Second Drive: 1. Start Windows and allow the operating system to boot to the desktop. Note: Be sure you are logged in as System Administrator. 2. Once Windows has fully booted up, click the Start button, right-click My Computer, then click Manage. 3. When Computer Management opens, click Disk Management. 4. When Disk Management opens, the Initialize and Convert Disk Wizard may appear. Note: You must use this wizard to write a Signature to the drive. Otherwise, the drive will not work with Windows.
Regulatory Compliance Return Material Authorization (RMA). If it is determined that the Product may be defective, you will be given an RMA number and instructions for Product return. An unauthorized return (i.e., one for which an RMA number has not been issued) will be returned to you at your expense. Authorized returns must be shipped in an approved shipping container, prepaid and insured, to the address provided on your return paperwork.
