Product Manual

7
2.8 TRANSPORT SAFETY
1. Read and follow the Operator's Manual before
using the TransCube.
2. Review and follow the User's Notice inside the
lid before using.
3. Be familiar with the requirements of "Trans-
port of Dangerous Goods" regulations and
follow them.
4. Train all drivers about the requirements of
transporting an Intermediate Bulk Container
(IBC). Do not allow untrained personnel to
drive.
5. Be sure each driver has the appropriate driv-
ers licence required by the Federal, Provin-
cial/State or local authorities.
6. Keep shipping papers describing tank and
contents with vehicle at all times.
7. Keep current Test Record Card with tank at all
times.
8. Keep Transport of Dangerous Goods (TDG)
Regulation Placard with the appropriate UN
number on each of the vertical sides when
transporting. Cover placards when tank is
empty and purged.
9. Securely anchor tank to truck with bolts before
transporting.
10. Turn off pump (move lever down) and close
generator port valves.
11. Be sure filler cap is on and closed securely.
12. Be sure all outlets are securely closed/
plugged with plugs provided by the manufac-
turer.
13. Ensure outer tank is empty of spillage.
14. Close and padlock hatch to prevent vibration
releasing the catch.
2.9 MAINTENANCE SAFETY
1. Good maintenance is your responsibility.
Poor maintenance is an invitation to trouble.
2. Follow good shop practices.
- Keep service
area clean and
dry.
- Be sure electri-
cal outlets and
tools are prop-
erly grounded.
- Use adequate
light for the job
at hand.
3. Make sure there is plenty of ventilation.
Never use the engine of the transport vehicle
in a closed building. The exhaust fumes may
cause asphyxiation.
4. Before working on this machine. Disconnect
the power to the pump and close all valves.
5. Do not smoke when performing any mainte-
nance work. Keep sparks, open flames and
hot material away from work site.
6. Always use personal protection devices such
as eye, hand and hearing protectors, when
performing any service or maintenance.
8. Periodically tighten all bolts, nuts and screws
and check that all electrical connections are
properly secured to ensure unit is in a safe
condition.
9. When completing a maintenance or service
function, make sure all safety shields and
devices are installed before placing unit in
service.
10. Establish a lock-out tag-out policy for the work
site. Be sure all personnel are trained in and
follow all procedures.
7. A fire extinguisher
and first aid kit
should be kept
readily accessible
while performing
maintenance on
this equipment.