Product Manual

Each owner and user of the
TransCube should review this
manual as part of the regular
training and review procedure.
Follow all instructions.
. Remove corner sockets,
edging strip and install lift-
ing eyes.
. With the inner tank emptied
of fuel, lift it out using the
lifting eyes.
. Clean the inside of the outer
tank bund . Remove all
debris and liquids.
. Remove the access cover,
lift up the back end of the
inner tank, and draw off any
residue with a pipe inserted
into the tank.
. If it is necessary to enter the
tank, care should be taken,
and a safe working proce-
dure drawn up and follow it.
. ressure wash out the tank,
drain tank, then dry. An
internal inspection can now
be made.
It is recommended the leak test
is carried out after the internal
inspection. Replace pressure
vacuum relief valve with a plug
for the leak test. Reassemble
the tank and install a new gas-
ket around the access cover.
Secure using x bolt-
nut assemblies. Tighten to
ft. lbs. torque to ensure there is
no leakage.
Install a new pres-
sure vacuum relief
valve that is avail-
able from Western.
Fi . INNER TAN REMOVAL
. CLEANING
With Tan Empty
. Remove the corner lift-
ing stacking sockets.
. Remove the edging
strip along the top of
each side.
eak proof test at kpa for min-
utes.
eep records of testing with the unit
at all times.
Reassemble
Dismantle
Drain Plu s
NOTE
Mark or identify each
component prior to re-
moval to allow reassem-
bly in the same location.
. Screw in lift-
ing eyes into
sockets on
the top of the
tank.
. Attach lifting system and lift
straight up.
. Clean the inside of the bund.
. Reassemble in the reverse or-
der.
. Tighten fasteners to their speci-
fied torque.