Product Manual
Table Of Contents
- INTRODUCTION
- DESCRIPTION
- IDENTIFICATION MARKS
- SIGN-OFF FORM
- UNIT SPECIFICATION
- SAFETY
- ACCESS AND SECURITY
- CABINET OVERVIEW
- CENTRE OF GRAVITY
- LIFTING & HANDLING
- FILLING THE TCG
- DISPENSING FUEL
- TRANSPORTING
- MARKINGS
- STACKING
- STRAPPING CHARTS
- MAINTENANCE AND SERVICE SCHEDULE
- STATUTORY INSPECTION AND MAINTENANCE
- INNER TANK REMOVAL
- ENVIRONMENTAL RESPONSIBILITY
- TROUBLE-SHOOTING
- WARRANTY
WM002-NA 40, 50TCG(G)-EN Revision 1
18
Positioning
Where the TCG is to be permanently positioned for use (long or short term) it
is important that certain aspects are considered
• You should make sure that both supplying vehicle and receiving vehicle
have safe and easy access to the TCG
• The position should be selected where the unit will be protected from
accidental impact
• Consideration should be given to the location of overhead services such
as telecommunications, power cables and overhanging obstructions. Be
aware of the location of underground services, such as drains, and
manhole covers
• You must also consider the ground surface and make sure it can support
the weight of the TCG, its contents when full and any stored equipment
such as pumps, without the risk of subsidence. It should be positioned on
smooth and level ground with access available to the rear and sides
• Allow for access that may be required by the emergency services should
it become necessary
• CONSULT WITH AUTHORITY HAVING JURISDICTION PRIOR TO
INSTALLATION.
FILLING THE TCG
• DO NOT FILL TANK WHEN DISPENSING IS IN OPERATION
• Only fill the TCG to 95% of its nominal capacity
• Filling should only be performed by a suitably trained person and only
following a full risk assessment
• The TCG must be positioned on a firm level surface, whether static, truck
or trailer mounted
• Where truck or trailer mounted, ensure that the parking brake is set to
ON and the wheels are chocked
• Before filling, ensure that you have a suitable spill containment kit and
that you are wearing all required PPE
• Nozzle Fill - Unscrew and remove the 3” filler cap, place the filling nozzle
in the 3” port.
• Hard Couple fill (EU Only) - Unscrew and remove the 2” filler cap, connect
the 2” delivery hose. Remove the 3” cap to allow venting
• Do not leave the nozzle unattended during the filling process
• Observe the fuel level gauge for an indication of tank capacity, then once
filled, replace the filler cap and clean up any spills