Product Manual B

WM006 FCP250, 500, 1000, 1800 V1 EN Feb 2020

Positioning

Where the FCP is to be permanently positioned for use (long or short term) it is

important that certain aspects are considered

• You should make sure that both supplying vehicle and receiving vehicle have

safe and easy access to the FCP

• The position should be selected where the unit will be protected from

accidental impact

• Consideration should be given to the location of overhead services such as

telecommunications, power cables and overhanging obstructions. Be aware

of the location of underground services, such as drains, and manhole covers

• You must also consider the ground surface and make sure it can support the

weight of the FCP, its contents when full and any stored equipment such as

pumps, without the risk of subsidence. It should be positioned on smooth

and level ground with access available to the rear and sides

• Allow for access that may be required by the emergency services should it

become necessary

FILLING THE FCP

• DO NOT FILL TANK WHEN DISPENSING IS IN OPERATION

• Only fill the FCP to 95% of its nominal capacity See UNIT SPECIFICATION

• Filling should only be performed by a suitably trained person and only

following a full risk assessment

• The FCP must be positioned on a firm level surface.

• Before filling, ensure that you have a suitable spill containment kit and that

you are wearing all required PPE

• Nozzle Fill - Unlock and open the access lid. Unscrew and remove the 3” filler

cap, place the filling nozzle in the 3” port

• Do not leave the nozzle unattended during the filling process

• Observe the fuel level for an indication of tank capacity, then once filled,

replace the filler cap and clean up any spills