User Manual

WESTERN JUSTICE LASSO SCOPE MOUNT
1) Remove the elevation ramp from the
rear sight of the gun by lifting up on the
rear sight and sliding the ramp towards
the muzzle end of the gun. Pull up on the
ramp as you slide it back and it will lift
out of the rear sight.
2) Remove the stock screw at the top rear
of the receiver using a phillips head
screwdriver by turning counter-clockwise.
3) With the tab on the mount facing up,
raise the rear sight and insert the mount’s
leading edge (where the tab is) under
the rear sight. The tab will t into the slot
that holds the elevation ramp (3a). Slide
the mount forward until the slot in the
underside of the mount is aligned over
the rear sight adjustment stopper
protruding at the top of the receiver (3b).
4) Align the rear anchor hole in the mount
over the hole for the stock screw at the
top rear of the receiver.
5) Notice there are two holes in the rear of
your LASSO mount. The rear most hole is
for the Daisy Red Ryder, the front hole is
for the John Wayne Lil’ Duke & Lil’ Sure
Shot. Make sure that you select the
correct hole for your rie.
NOTE: The Lil’ Duke & Lil’ Sure Shot may only
require one shim to properly sight in the rifle. There
may also be instances where no shims are needed.
6) Lift up on the rear sight and insert
the elevation ramp into the slot in
the rail.
7) Insert the two (2) black nylon
spacers between the mount and
the receiver. Align the spacers
under the rear anchor hole in the
mount and over the stock screw
hole.
NOTE: While two spacers is recommended,
due to the wide variety of scopes and
mounts available you may need to change
the number of spacers to work best with
your chosen scope and mount.
8) With the front of the mount secure
and the spacers installed, place
the lock washer on the rear stock
screw. Replace the stock screw
using a phillips head screwdriver
by turning clockwise.
9) You can now install any standard
3/8” dovetail mounted scope, red
dot sight or laser sight on your
Red Ryder, Lil’ Duke or Lil’ Sure
Shot. Enjoy!
1
2
6
7
8
9
DIRECTIONS FOR INSTALLATION
Air Venturi • 5135 Naiman Parkway, Cleveland, OH 44139 • Ph: 216-292-2570 • fax: [phone] • www.airventuri.com
Western Justice
™
brought
to you by Air Venturi
Make sure your rie is unloaded
before beginning installation.
WARNING:
!
5
ver. 7-11-17
3b
4
3a