User`s guide

5.6. Copying Parameters to Several
RS-232 Ports
The /CP command (Copy Port Parameters) provides a convenient
means for selecting similar parameters for all or several CMS
RS-232 ports.
When the /CP command is invoked, the unit will display a menu
which allows you to select parameters, and then copy them to all
or several CMS RS-232 ports. The Copy Port Parameters menu
can be used to set all parameters for the specified port(s), or
define only a select group of parameters for the desired ports.
Notes:
·
The /CP command will not copy parameters to the
Network Port.
·
The /CP command is only available in Supervisor
Mode.
·
The Copy Port Parameters Menu will not display
the Port Password. This field will read either
“undefined” or “defined”, depending upon whether
or not the Port Password has been specified.
·
The /CP command cannot be used to set Ports 1
and 2 to Passive Mode or Buffer Mode (Port Mode,
Item 7).
·
The /CP command cannot be used to disable the
Supervisor Mode at Ports 1 and 2 (Supervisor
Mode, Item 8).
5-21
Configuration
Figure 5.5: The Copy Port Parameters Menu