Installation guide

1
1-8
UltraNet Storage Director Hardware Installation Guide
Cables and Equipment
Customer-Supplied
Cables and
Equipment
The specific host and network cables for the external cable
connections must be supplied by the customer. Table 1-2 lists the
hardware specifications for the customer-supplied equipment.
NOTE: Your installation may not require all the equipment listed below, as it
is site-specific.
Power Cord
Requirements
The USDX requires one 15 amp outlet for each power supply
installed in the system. The maximum number of power supplies per
F9112 system is 4. The maximum number of power supplies per
F9106 is 2.
NOTE: In addition to the above power requirements, 2 or more power outlets
are required for peripheral equipment including the PC and the modem.
Table 1-2 Customer-Supplied Cables and Equipment Specifications
Cable and Equipment Description
Power Receptacles See the “Power Cord Requirements” section to determine the appropriate
receptacle/power cord.
Outside Analog Telephone An external analog RJ-11 plug type telephone line is required for
McDATA Customer Support Services access.
ESCON Cables This is from the standard IBM ESCON cable specifications.
Ethernet Transceiver Attachment Unit Interface (AUI) connection DB-15 pin transceiver
connector to customer dependent connection.
ATM (O C-3 )
ATM/POS (OC-12)
Fibre Channel
FICON
T3
Ethernet 10/100
Gigabit Ethernet
The customer should ensure conformance to the specifications provided
in the “Cable and Connector Specifications” section of the UltraNet
Storage Director - eXtended Site Preparation User Guide.