User`s guide

15-6
PollCat NetLink II - User’s Guide
4. Enter "Read" Session: When this item is selected, NetLink II will
display a submenu before beginning data release. The following
options are available:
a) Start Data Output: To begin, press [Enter].
b) Next Group (^B02): Used when releasing groups of records as
described in Section 15.2.2. To release the next group, invoke
command ^B02.
c) Re-read Last Data Record (^B06): Used when releasing
groups of records (Record Count) as described in Section 15.2.2.
To resend a group, invoke command ^B06.
d) Exit (^B30): To exit data release mode and return to the Buffer
Functions menu, invoke command ^B30.
Notes:
• When all specified records have been released, the "End
Data" message is sent. If "Hold End Data" is enabled, a ^B02
command is required in order to release the End Data message
and complete the data release procedure.
• If "Data On ^B01" is disabled, a ^B02 command must be sent in
order to begin the data release.
5. Erase Partition Data: Erases all data in the current memory partition.
NetLink II will display a "Sure?" prompt; if confirmation is given, all
data in the partition will then be erased. Note that this function will
not erase records received after the partition was set.
6. Erase All Data: Erases all stored records, including records in
partitions owned by other ports. Note that NetLink II will not erase
records that are currently being read by another port.
BUFFER FUNCTIONS:
1. "Read" Session Parameters
2. Set Partition
3. Release Partition
4. Enter "Read" Session
5. Erase Partition Data
6. Erase All Data
7. Erase All Data & Clear Alarm Clue Counters
8. Release Remote Partition
Enter Selection,
Press <ESC> to return to previous menu ...
Figure 15.2: Buffer Functions Menu