User guide

T R A F F I C A N A L Y S T A D M I N I S T R A T I V E G U I D E
J U N E 20 11 I M P A C T T E C H N O L O G I E S , I N C 33
C O N F I D E N T I A L A N D P R O P R I E T A R Y
2.1.3.9 Siemens HiPath 4000 TCP/IP Communications
Select TCP/IP radio button under Communicate Via.
Node ID identifies the node of the switch. This may be a single node number a set of 3
numbers displayed from the switch. If it is a single number, enter it as a single number.
Traffic Analyst will enter the preceding zeros. If it is a set of 3 numbers, enter the numbers
in the format of x.y.z, where x is a number between 0-99, y is a number between 0-999
and z is a number between 1-999.
Note: Node ID is not needed if using AMO Data Collection or Auto Configure Switch
CDR.
TCP/IP Section
Choose either Host or IP Address. If using AMO Data Collection, which is
recommended, then select IP and enter in the IP address of the HiPath 4000 Assistant. If
using Collection Agent for data collection then you will need to enter in either the Host
name or IP address for the HiPath Manager or HiPath Assistant.
*Host is usually a name where IP Address is a string of numbers.
Check AMO Data Collection to retrieve the data directly from the switch, without having to
use Collecting Agent. If this option is not checked, data will be retrieved from the HiPath
Manager or HiPath Assistant using Collecting Agent. Notice many of the fields below will
become grayed out once checking AMO Data Collection.
Check Auto Configure CDR Switch to automatically run the AMO data collection
commands on the switch in order to configure Call Detail data collection. If this option is
not checked, the AMO commands will need to be entered manually on the switch.