Instruction manual

WESTFIRE WF23/UNIQ 23 INSET, WESTFIRE WF32/UNIQ32 INSET
WF32/UNIQ32 INSET
Narrow frame
WF32/UNIQ32 INSET
Wide frame
WF23/UNIQ23 INSET
Std frame
Height (frame)
610mm
570mm
660mm
Width (frame)
880mm
1000mm
670mm
Height (stove box)
555mm
555mm
600mm
Width (stove box)
810mm
810mm
610mm
Depth (stove box)
405mm
380mm
375mm
Closed combustion
fitted as standard
NOT AVALIABLE
NOT AVAILABLE
OPTIONAL
Westfire Insulated chambers
The WESTFIRE WF32/UNIQ32 AND WF23/UNIQ23 stove is lined with heat deflection panels and baffles,
these panels are designed to ensure the maximum efficiency and are an integral part of the clean burn
process of the stove. These baffles should not be removed other than for cleaning the stove. Any defective
panels should be replaced.
Commissioning and handover
Ensure loose parts are fitted in accordance with the instructions given in the instruction booklet.
On completion of the installation allow a suitable period of time for any fire cement and mortar to dry out,
a small fire may be lit to check that smoke and fumes are taken from the stove up the chimney and emitted
safely into the atmosphere. Do not run at full output for at least 24 hours.
On completion of the installation and commissioning ensure that the operating instructions for the stove are
left with the customer. Ensure to advise the customer on the correct use of the appliance with the fuels
likely to be used on the stove and notify them to use only the recommended fuels for the stove.
Advise the user what to do should smoke or fumes be emitted from the stove. The customer should be
warned to use a fireguard to BS 6539 in the presence of children, aged and/or infirm persons.