User Manual
10 | Westinghouse Portable Power
120-Volt 30 Amp TT-30 Outlet: Travel Trailer outlet
can supply a maximum of 30 amps and 120 volts.
120-Volt, 20-Amp Duplex: The outlet is capable of
carrying a maximum of 20 amps.
USB Duplex: 5V DC USB outlets that come with 1 and
2.1 amp rating. 5-Volt DC USB devices or extension
cords must be tted with a standard Type “A” USB
male plug for connection to the generator.
Eciency Mode Switch: Move the switch to the
ON position when powering small resistive loads such
as a computer or electric light; the engine speed will
automatically be kept to a minimum, thereby reducing
fuel consumption and noise. Select the OFF position
when powering large inductive loads such as an air
conditioner or electric pump; the engine speed will be
kept higher for maximum electrical starting power.
30-Amp Circuit Breaker: Circuit breaker limits the
current that can be delivered through the 120-volt
TT-30R outlet to 30amps.
Ground Terminal: The ground terminal is used to
externally ground the inverter.
20-Amp Circuit Breaker: Circuit breaker limits the
current that can be delivered through the 120-volt
duplex outlets to 20amps.
VFT Data Center: Press and release the mode
button to toggle between Voltage, Frequency,
Total Hour Meter and Run/Maintenance Timer.
Frequency in hertz
Lifetime run hours
Run/Maintenance
Voltage
The Run/Maintenance Timer displays the time in
hours and minutes each time the generator is ran.
The run timer resets to 00:00 when the generator is
shut o. Built into this run timer is a maintenance
reminder. When the new generator is ran for 25
hours, the meter will display P25. This is to remind
you to change the oil after the initial 25 hours of run
time. When it displays P50, it is time to clean the air
lter. When it displays P100 it is time change/clean
the fuel lter, clean the air lter, and change the oil.
Engine Control Switch: Switch to “Stop” to stop
the engine. Switch to “Run” before starting engine.
Indicator Lights:
Low Oil LED: Indicates low oil level.
Overload LED: Indicates that the inverter is
overloaded.
Output Ready LED: Indicates the inverter is ready
to be used.
Reset Breaker: If the inverter is overloaded, the
reset breaker will trip. The engine will continue to run,
but there will be no electrical power output from the
inverter. Unplug the devices and reduce the load.
Push in the reset breaker to reset it.
CONTROL PANEL FEATURES
1
8
9
10
11
2
3
4
5
6
7
2
3
1
4
7
6
8
5
9
10 11
FEATURES