User Manual

Westinghouse Portable Power | 15
4. Make sure the circuit breakers are properly set (see
Figure 2 below).
1
1
2
2
120V Breaker Operating Position
120V Breaker Tripped Position
Figure 2: Breaker position
5. Turn the fuel valve switch to ON position
(see Figure 3).
Figure 3: Fuel valve - ON
6. Push the engine control switch into the RUN position
(see Figure 4).
Figure 4: Engine control switch - RUN
7. For cold starting, pull out the choke lever on the
control panel (see Figure 5).
Pull out: Choke On
Figure 5: Pull choke lever
8. Firmly grasp and pull the recoil handle slowly until
you feel increased resistance. At this point, apply a
rapid pull while pulling up and slightly away from the
generator.
9. As the engine starts and stabilizes, push the choke
lever in.
10. Plug in devices.
STARTING THE INVERTER
BEFORE STARTING THE INVERTER,
REVIEW SAFETY SECTION.
For proper starting and operation of the inverter, make
sure you review the inverter control panel features and
their descriptions.
Before attempting to start the inverter, verify the
following:
• The engine is lled with engine oil (see Engine Oil
Correct Level).
• The inverter is situated in a proper location (see
Location Selection).
• The inverter is on a dry surface (see Weather and Dry
Surface).
• All loads are disconnected from the inverter (see No
Connected Loads).
• The inverter is properly grounded (see Grounding the
Inverter)
DANGER
Never use the inverter in a location
that is wet or damp. Never expose
the inverter to rain, snow, water
spray or standing water while in use.
Protect the inverter from all hazardous
weather conditions. Moisture or ice
can cause a short circuit or other
malfunction in the electrical circuit.
Never operate the inverter in an
enclosed area. Engine exhaust
contains carbon monoxide. Only
operate the inverter outside and away
from windows, doors and vents.
Starting iGen4200
1. Move inverter to a at surface outside in a well
ventilated area away from open doors or windows.
2. Check oil levels. If it is the rst time starting make
sure to add oil (see Adding Engine Oil).
3. Disconnect all electrical loads from the generator.
OPERATION