Technical Literature
State of the art compressor is standard
equipment.
Earth friendly non-ozone depleting
refrigerant.
Ensure long compressor life.
Outdoor coils are designed
to optimize heat transfer, minimize size and cost, and increase
durability and reliability.
for increased resistance against
formicary corrosion, the number one cause of coil leaks.
~ The 2, 2.5 and 3 ton models include all-aluminum
Anteater Micro-channel technology.
~ The 3.5, 4 and 5 ton models include Anteater™ tubing
technology.
with a polyester urethane coat
finish. The 950 hour salt spray finish is 1.5 mil thick and resists
corrosion 50% better than comparable units.
make the Q7 Series easy to
install and transport.
to combustibles on duct side of the unit allows
for installations in tight areas.
A guard that will never rust and protects the
units coil from being damaged.
allows water to drain away from away from
the unit.
Designed to make
servicing easier for the contractor, access panels are provided
to all controls and the compressor from the side of the unit.
to the evaporator coil for cleaning and general
maintenance.
Allows ease of service to
the fan motor.
a reliable, industry standard control
offers various time settings to meet any type climate.
when the units shuts down,
a five minute delay keeps the unit from restarting, eliminating
the highest cause of compressor failure.
Factory installed at a convenient
location for service.
simplify servicing of the refrigeration
system.
provides protection from liquid flood
back and future compressor failures.
A heavy duty
PSC motor for long lasting reliability and quiet operation.
Includes 3 Amp fuse to protect low
voltage circuit.
design optimizes drainage capabilities.
is standard equipment.
Field installed 5 – 20 KW.
The Q7 Series single packaged heat pumps are high
efficiency self contained cooling and heating units that
can be installed on a slab. Units are ETL and ETLc listed.