User Manual Steam Iron MODEL: WSI100 WSI200 WSI300 WSI400 1. READ these instructions carefully before installing and operating the steam iron. Keep them for further reference. 2. Record in the space below the “SERIAL NO.” found on the nameplate on your steam iron and retain this information for future reference. SERIAL NO.: Please save sales receipt for warranty.
CONTENTS SAFETY INFORMATION SAFETY INFORMATION DANGER Important Safety Instructions 3 Electrical Requirements 5 DANGER - Immediate hazards which WILL result in severe personal injury or death WARNING WARNING - Hazards or unsafe practices which COULD result in severe personal injury or death CAUTION CAUTION - Hazards or unsafe practices which COULD result in minor personal injury SET UP & USE Installation Guide 5 Parts & Features 6 Operation Instructions 7 Functions 8 Helpful Tips 10 IMP
SAFETY INFORMATION 9. The plug and cord should not be allowed to touch the hot sole plate. Let the iron cool down completely before taking it away. Coil the cord loosely around the iron for storage. 10. Always disconnect the iron from the wall outlet before filling with water or when emptying the water after use. 11. To avoid an overloaded circuit, do not operate another high voltage appliance in the same electric circuit. 12.
SET UP & USE SET UP & USE PARTS & FEATURES OPERATION INSTRUCTIONS WSI100 & WSI200 HOW TO FILL WITH WATER Spray Button Temperature Control Knob 1. Burst of Steam Button Steam Control Knob Water Inlet Thermostat Operating Indicator Light 2. Unplug the iron from the wall outlet, and wait for the iron to cool down. Heel Rest 3. Pour water into the Water Inlet: -Fill up to the maximum level “MAX.” Do not over fill.
SET UP & USE SPRAYING (ALL MODELS) This function can be used with stream or dry ironing and does not affect the ironing temperature 1. Check the water level. Add water if needed. 2. Aim the nozzle towards the garment. 3. Press the Spray Button, . Repeat if spray does not work immediately. 5. The temperature operating indicator light turns off when the required temperature is reached. The iron is ready for use. The light will go ON and OFF while ironing. 6.
SET UP & USE CLEANING AND CARE AUTO SHUT-OFF (TIMED, 3-WAY, ETC) (ONLY APPLIES TO WSI200, WSI300 AND WSI400) max The Auto Shut-Off feature (or setting the thermostat to “OFF”) is not intended to take the place of unplugging the cord. Disconnect the electric iron when not in use! Even though the iron is unplugged the soleplate is still hot. Be sure to rest the iron on its heel, away from fabric. 1. When the iron is not moved with the soleplate facing down (Fig. A) or lying on its side (Fig.
CLEANING AND CARE TROUBLESHOOTING & WARRANTY STORAGE (ALL MODELS) BEFORE YOU CALL FOR SERVICE 1. IF THE STEAM IRON FAILS TO OPERATE: Turn the Temperature Control to “•” and set the Steam Control Knob to position “0” (=no steam). 2. Disconnect the iron from the wall outlet. 3. Pour any remaining water out of the water tank. 4. Stand the iron upright and let it cool down completely. 5. The power cord can then be wound around the iron. 6. Always store the iron in an upright position.
TROUBLESHOOTING & WARRANTY MEMO LIMITED WARRANTY Westinghouse brand is used under license. Any repair, replacement, or warranty service, and all questions about this product should be directed to W Appliance Co. at 1 (855) 855-0294 from the USA or Puerto Rico. W Appliance Co. warrants to the original purchaser that the product will be free from defects in material, parts and workmanship for the period designated for this product.
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF are trademarks of Westinghouse Electric Corporation. Used under license by W Appliance Company LLC. All Rights Reserved.