Use and Care Manual

Page 4 Page 5
SAFETY INFORMATION
13. Scalding may occur if the cover is lifted or removed during the
brewing cycle.
14. Snap the cover securely to the carafe before serving.
15. Carafe is designed for use with this appliance. Never use the carafe
on a range top or in a conventional oven. Do not put carafe into a
microwave oven.
16. Do not set a hot carafe on a wet or cold surface.
17. Do not use a cracked carafe, or a carafe that has a loose or
weakened handle.
18. Do not clean the coffee maker with scouring powders, steel wool
pads, or other abrasive materials.
SAFETY INFORMATION
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
ELECTRICAL REQUIREMENTS
POWER SUPPLY CORD
This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug is intended to t into a polarized outlet only one way.
If the plug does not t into the outlet, reverse the plug. If it still does not t, contact a
qualied electrician. Do not attempt to modify the plug in any way.
1. A short power supply cord is provided to reduce the risk of becoming entangled in
or tripping over a longer cord.
2. If the power supply cord is too short, do not use an extension cord. Have a
qualied electrician or serviceman to install an outlet near the appliance.
3. If it is absolutely necessary to use longer cord sets or an extension cord, extreme
care must be exercised.
a) The marked electrical rating of the cord set or extension cord must equal to
or be greater than the electrical rating of the appliance. The longer cord should
be arranged so that it will not drape over the counter top or table top where it
can be pulled on by children or tripped over unintentionally.
b) If the appliance is of the grounded type, the extension cord should be a
grounding type 3-wire cord.
c) The longer cord should be arranged so that it will not drape over the countertop
or table top where it can be pulled on by children or tripped over.
NOTE: Neither Westinghouse nor the dealer can accept any liability for damage to the product or
personal injury resulting from failure to observe the electrical connection procedures.