Programming instructions

- Page 23 -
IL 30-471 (E)
10. Voltage and/or frequency cards may be removed from
a ROBONIC (for servicing, etc.) without disruption of
power supply to the connected load. Output relays
NR and ER, in combination with their timers or driv-
ers, will continue to provide partial protection. Drop-
out voltage is 50%; pickup voltage is 70%.
Note:
When servicing logic control, or transformer module,
disable the motor circuit.
TYPE LRO ROBONICS
CAUTION
Do not overtighten the pivot screw inside the operat-
ing arm. This screw was correctly adjusted at the fac-
tory to provide low friction movement of the operating
arm without excessive play.
Do not overtighten the set screw holding the operat-
ing cam on the motor shaft.