Replacement Part List

OPERATION
Using Extension Cords – Westinghouse Portable
Power assumes no responsibility for the content within
this table. The use of this table is the responsibility of
the user only. This table is intended for reference only.
The results produced by using this table are not
guaranteed to be correct or applicable in all situations
as the type and construction of cords are highly
variable. Always check with local regulations and a
licensed electrician prior to installing or connecting an
electrical appliance.
Extension Cord Wire Gauge Size
INVERTER PARALLELING
OPERATION
!
DANGER
Never connect the paralleling cord to
the inverters with the inverters running.
The inverters must not be running and
both the paralleling cord switches must
be off when connecting the cords.
!
WARNING
Do not attempt to parallel the
Westinghouse inverter with any other
manufacturers’ inverters. Do not use
the paralleling cord for any application
other than inverter paralleling. Do not
use this cord on other manufacturers’
inverters.
!
WARNING
Always ensure that both ends of the
paralleling cord are switched off before
connecting the inverters.
1. Using only the Westinghouse paralleling cord (Part
No. 260041) with both cord switches set to OFF
(O), connect one male plug to one inverter and
connect the remaining plug into the other inverter.
Either of the receptacles on the inverters can be
used (see Figure 15).
Figure 14 – Paralleling Cord ON/OFF Switches
12