Installation Sheet

LED 4” RETROFIT TRIM INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may
need them at a later date.
GENERAL: All electrical connections must be in accordance with local and
National Electrical Code (N.E.C.) standards. If you are unfamiliar with proper
electrical wiring connections obtain the services of a qualified electrician.
Remove the trim from the box and make sure that no parts are missing by
referencing the PARTS illustrations. The rubber behind the trim will make the
down light completely flush with ceiling all the way around for better installation.
THIS RETROFIT ASSEMBLY IS ACCEPTED AS A COMPONENT OF A LED
LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL BE
DETERMINED BY CSA OR CANADIAN AUTHORITIES HAVING JURISDIC-
TION.
WARNING: RISK OF ELECTRIC SHOCK. INSTALL THIS TRIM IN
RECESSED HOUSINGS THAT HAVE DIMENSIONS SHOWN IN
FIG. 1.
WARNING - Risk of fire or electric shock. LED Retrofit Kit installation requires
knowledge of luminaire electrical systems. If not qualified, do not attempt
installation. Contact a qualified electrician.
WARNING - Risk of fire or electric shock. Install this kit only in the luminaires
that have the construction features and dimensions shown in the photographs
and/or drawings.
Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation.
WARNING - To prevent wiring damage or abrasion, do not expose wiring to
edges of sheet metal or other sharp objects.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTRALLATION CODE BY A PERSON FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED.
ASSEMBLY AND INSTALLATION
INCANDESCENT HOUSINGS
1. Turn off power at circuit box to avoid possible electric shock.
2. Thread the SOCKET ADAPTER into the SOCKET. (FIG. 2)
3. Plug the CONNECTOR of the RETROFIT TRIM onto the CONNECTOR of
the SOCKET ADAPTER ASSEMBLY. (FIG. 3)
4. Tuck all wires into the CAN and carefully push the RETROFIT TRIM into
CAN. (FIG. 4)
DIMMING
Although this product is compatible with most common residential type dimmers, dimming
performance depends on dimmer, dimmer setting (for dimmers with brightness range
adjustments), wiring method, and the number of LED modules. For best results, set dimmer
position at maximum before adjusting to a lower light level.
Recommended Dimmers (minimum load for four LED modules maybe required for optimal
dimming performance): LEVITON: 6683, 6631-LA, 603-6631-A, 6631-A, NO.IPL06,
IPI10-1LZ, 6683-10Z, IPI06-1LZ and LUTRON: S-603PH-WH
FIVE-YEAR LIMITED WARRANTY
Westinghouse Lighting warrants that this lamp will be free from defects in
material and workmanship and will work for 5 years (based on up to 3 hours
average usage per day for 7 days per week). If the product fails during the
warranty period, return defective product to retailer. Warranty terms and
conditions of retailer apply. If replacement product is not available at retail store,
please contact [e-mail] or return the
product in the original package with receipt to manufacturer at: 12401 McNulty
Road, Philadelphia, PA 19154-1029. This limited warranty does not cover lamps
subject to accident, neglect, abuse, misuse or acts of God. REPLACEMENT IS
YOUR SOLE REMEDY. EXCEPT TO THE EXTENT PROHIBITED BY
APPLICABLE LAW, ANY IMPLIED WARRANTIES ARE LIMITED TO THE
DURATION OF THIS WARRANTY PERIOD. LIABILITY FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES IS EXPRESSLY EXCLUDED. Some states do
not allow exclusion of incidental or consequential damages, so the above
exclusion may not apply. This warranty gives you specific legal rights, but you
may also have other rights that vary from state to state.
WARNING - RISK OF ELECTRIC SHOCK. DISCONNECT MAIN
POWER AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLING
OR SERVICING THE FIXTURE.
5 ½ in.
4 in.
FIG. 1
FIG. 2
FIG. 3
PARTS
SOCKET ADAPTER
ASSEMBLY
HOUSING DIMENSIONS
FIG. 4
RETROFIT TRIM
ESF-WH-038
Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A.
www.westinghouselighting.com
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF
are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting
All rights reserved.
Made in China