Instructions / Assembly

CAUTION
1. SUITABLE FOR OPERATION WITHIN THE TEMPERATURE RANGE OF: -20°C - 40°C.
2. SUITABLE FOR USE IN WET LOCATIONS.
3. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
4. CAUTION – RISK OF FIRE.
5. ALL COMPONENTS IN THE LUMINAIRE SHALL NOT BE REPLACED OR SERVICED.
6. The electrical installation must be carried out in accordance with the current national electrical
regulations.
7. The power (supply) cord is supplied as an accessory to work with the built-in connector on
the tube light. Connect the tube light in series and terminate the M12 male connector
on the nal tube in the series by using the M12 connector cap.
8. In the interests of electrical safety, an earth leakage protective device should be installed in the
supply circuit. This may be part of a consumer unit or a separate unit.
9. Turn o the electrical supply before connecting the power cord. Always take care of the
working load in the cables when multiple products are installed in cascade.
10.This appliance must be grounded via the power cord plug and the electrical supply to the
socket and must be correctly connected to the ground point in the terminal box or consumer
unit.
Wiring Diagram:
This tube can be used in single or multiple tube setups with up to a maximum of 10 tubes on one
power cord. NOTE: The power cord not included, Westinghouse item number: 63658-6930.
Multiple connection:
Single connection:
Warranty
This Westinghouse Lighting Fixture is warranted against defects in material and workmanship for a
period of Five Years from purchase date. This warranty is in lieu of all other warranties expressed
or implied. This warranty does not cover acts of nature such as lightening damage, or corrosion
and discoloration of components, nor does it cover damages caused through abuse, improver
installation, surges in electric current, or acts of third parties. This warranty does not cover the costs
of removing and re-installing the lighting xture. If this product fails for any reason covered by this
warranty, please contact us at www.westinghouselighting.com/contact-us.
INSTALLATION
1. Fixed installation: Use M3 self-tapping screw to attach the plastic clip onto the structure.
Keep proper distance between the clips but at least two clips shall be used for each tube.
Insert the tube into the clips and adjust the lighting direction. (You can use nylon cable ties
to attach the tube if there is xed support already in place.)
2. Hanging installation: Connect one end of the attached chain to the plastic clip and hang
the other end to the structure. Insert the tube into the clips (two clips for each tube). Adjust
the chain length and the rotate the tube to achieve the required lighting direction.
INSTRUCTIONS MANUAL
ESF-WH-065
1
, Westinghouse, and INNOVATION YOU CAN BE SURE OF are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting. All Rights Reserved. Made in China
Packing list
Parts
Tube-4ft
Plastic clip
M3 self-tapping screw
Q’ty
1pc
3pcs
3pcs
M12 connector cap
M12 connector cap