Owner's Manual

12
ETL-ES-Morris-WH20
This remote control unit is equipped with 16 code combinations to prevent possible
interference from or to other remote units. The frequency switches on your receiver
and transmitter have been preset at the factory. Please recheck to make sure the
switches on transmitter and receiver are set to the same position, any combination
of settings will operate the fan as long as the transmitter and receiver are set to the
same position.
Esta unidad de control remoto está equipada con 16 códigos de combinación
para prevenir posibles interferencias con otras unidades de control remoto. Los
interruptores de frecuencia en su receptor y transmisor han sido programados en
fábrica. Por favor verifique que los interruptores en el transmisor y el receptor estén
en la misma posición, cualquier combinación hará funcionar el ventilador siempre y
cuando el transmisor y el receptor estén en la misma posición.
WIRING OPTIONS
OPCIÓN DE CABLEADO
12
13
Bare Copper or Green
Cobre Pelado o Verde
Green
Verde
Green
Verde
Make wiring connections from the house and the motor to the remote receiver as shown
above. Connect using wire nuts (provided).
Haga las conexiones de cableado del alojamiento y el motor al receptor remoto como se
indica más arriba. Utilice las tuercas para cables (incluidas).