Owner's Manual

26
OPERATION
Transfer Switch Cord
The transfer switch cord, 10KPRO Part No. 210051 and
8KPRO Part No. 210075, is an optional accessory for
the portable generator. It is used to connect the 50-amp
outlet on the 10KPRO and the 30-amp outlet on the
8KPRO of the generator to the transfer switch. If your
transfer switch does not come with a transfer switch
cord, order the cord from Westpro Power.
Figure 17 – Transfer Switch Cord, 10KPRO
Figure 18 – Transfer Switch Cord, 8KPRO
TRANSFER SWITCH
CONNECTIONS
The Westinghouse generator is wired with the neutral
bonded to ground. If you are connecting your generator
to a transfer switch, the electrician must first determine
what type transfer switch is being used. Transfer
switches for this equipment are either two-pole or three-
pole types.
A two-pole transfer switch will not switch the neutral
from the generator to the service panel. That means
the generator will be grounded to the service panel. To
use the generator with two-pole transfer switches, the
electrician will need to change the neutral from bonded
to floating.
Remove the ground screw from the wires (see Figure
19). Wrap the terminal end of the green wire with
electrical tape so it is insulated. Tape the green wire to
the yellow/green wire so it cannot contact any moving
parts. Connect the yellow/green wire back to ground
using the ground screw.
3
2
1
Figure 19 – Bonding Wire
1 - Ground Screw
2 - Green Wire
3 - Yellow/Green
Wire