iGen-Manual

20 | Westinghouse Portable Power
Drain Oil iGen2000, iGen2500 & iPro2500
7. Allow oil to completely drain.
8. Fill crankcase with oil following the steps outlined in
Adding Engine Oil on page 19
9. Dispose of used engine oil properly.
NOTICE
Never dispose of used engine oil by dumping the
oil into a sewer, on the ground, or into groundwater
or waterways. Always be environmentally
responsible. Follow the guidelines of the EPA or
other governmental agencies for proper disposal
of hazardous materials. Consult local authorities or
reclamation facility.
Oil Fill/Drain Funnel iGen1200
Oil Fill/Drain Funnel iGen2000, iGen2500 & iPro2500
1. Continue to add oil until the oil is at the correct level
(see Figure 2 on page 14).
CHANGING ENGINE OIL
1. Stop the engine.
2. Let engine sit and cool for several minutes (allow
crankcase pressure to equalize).
3. Remove the engine service panel to gain access to
the oil ll/drain plug.
4. Place oil pan (or suitable container) under the oil ll/
drain plug.
5. With a damp rag, thoroughly clean around the oil
ll/drain plug.
6. Tilt the inverter so the oil drains down the through
into the container.
Drain Oil iGen1200
MAINTENANCE