Full Product Manual
10 | Westinghouse Portable Power
FEATURES
BASIC INVERTER FEATURES IGEN2000, IGEN2500 AND IPRO2500
Fuel Cap and Vent: Open the vent to run the
engine and close the vent when the engine is o.
Control Panel: Contains the reset breaker,
outlets and warning lights.
Spark Plug Access Cover: Remove the cover
to service the spark plug.
Recoil Handle: Pull to start the engine.
Engine/Fuel Control Switch: Turns the engine
and the fuel on and o.
1
5
6
7
8
9
2
3
4
2
1
3
4
5
6
7
8
9
CONTROL PANEL FEATURES IGEN2000
120-Volt, 20-Amp Duplex Outlet (NEMA 5-20R):
The outlet is capable of carrying a maximum of
20 amps.
USB Duplex: 5V DC that come in 1 amps and
2.1 amps.
Reset Breaker: If the inverter is overloaded, the
reset breaker will trip. The engine will continue to
run, but there will be no output from the inverter.
Unplug the devices and reduce the load. Push in
the reset breaker to reset it.
Eciency Mode Switch: When turned to the ON
position, the engine will sense the load needed
and run at a slower RPM to save fuel.
Ground Terminal: The ground terminal is used to
externally ground the inverter.
Low Oil LED: Indicates low oil level.
1
2
3
4
5
6
7
8
9
Engine Service Panel: Remove the panel to access
the engine for maintenance.
Muer and Spark Arrestor: Avoid contact until the
engine is cooled down. The spark arrestor prevents
sparks from exiting the muer. It must be removed for
servicing.
Engine Cooling Vents: Helps move airow in unit to
regulate engine temperatures.
Recoil Handle Protective Cover: Prevents pull cord
wire from damaging inverter body.
Overload LED: Indicates that the inverter is overloaded.
Output Ready LED: Indicates the inverter is ready to
be used.
Fuel Control and Choke Switch: Turn position to
CHOKE to start the engine, and turn to RUN position
once the engine is running. Switch to OFF to stop inverter.
1
2
3
9
4
5
7 8
6