User Manual

18 | Westinghouse Portable Power

DRAINING THE FLOAT BOWL

1. Remove the Engine Service Panel to access the

carburetor (see Figure 13 on page 17).

2. Locate the clear plastic hose from the oat that is

extending towards the bottom of the inverter, pull those

hose outside the body and place a suitable container

under it to catch the drained fuel (see Figure 16).

Figure 16: Fuel Drain Hose

3. Loosen the oat bowl drain screw until fuel is seen

draining from the oat bowl (see Figure 17).

Figure 17: Loosen Float Bowl Screw

4. Allow fuel to drain into the container, and then tighten the

oat bowl drain screw.

NOTICE

Never dispose of fuel by dumping fuel into a sewer, on the ground,

or into groundwater or waterways. Always be environmentally

responsible. Follow the guidelines of the EPA or other

governmental agencies for proper disposal of hazardous materials.

Consult local authorities or reclamation facility.

5. Install the engine service panel.

SPARK PLUG MAINTENANCE

The spark plug must be checked and cleaned after every

100 hours of use or 6 months and must be replaced after

300 hours of use or every year.

1. Stop the inverter and let it cool for several minutes if

running.

2. Move the inverter to a at, level surface.

3. Remove the Engine Service Panel to gain access to the

spark plug (see Figure 13 on page 17).

4. Remove the spark plug cover by rmly pulling the

metal spark plug boot handle directly away from the

engine (see Figure 18).

Figure 18: Pull o Spark Plug Cover

NOTICE

Never apply any side load or move the spark plug

laterally when removing the spark plug. Applying a side

load or moving the spark plug laterally may crack and

damage the spark plug boot.

5. Clean area around the spark plug.

6. Using the spark plug socket wrench provided, remove

the spark plug from the cylinder head (see Figure 19).

Figure 19: Remove Spark Plug

MAINTENANCE

fuel pan