Instruction Manual

4
CAUTION: For fixtures labeled for outdoor and wet location use, provide a water-tight seal
between the fixture and the mounting surface by using silicone or similar caulking.
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These
fixtures meet all UL specifications.
1. Turn off power at circuit box to avoid possible electric shock.
2. Remove cap nuts (A) from back plate (B) and remove cross bar (C) (see fig. 1).
3. Secure cross bar (C) to outlet box (D) with outlet box screws (E) (not included).
4. Identify color coding of fixture wires (see figure 2 on page 11).
5. To connect wires, take black fixture wire (group A from fig. 2) and place evenly against
black outlet box wire. Do not twist wires.
6. Fit wire connector (F from fig. 1) over wires and twist until there is a firm connection. If
wire connector (F) easily comes off, reattach wire connector (F) and check again for a firm
connection (see figure 1).
7. Repeat steps 5 and 6 with the white (group B from fig. 2) fixture wire and outlet box wires.
8. Partially thread green grounding screw (G) into side hole (H) on cross bar (C) (see fig.1).
9. Wrap ground wire from fixture around green grounding screw (G), leaving enough excess
wire to then connect ground wire and outlet box wire with wire connector (F) (if applicable).
10. Tighten green grounding screw (G). Do not over tighten.
11. Tuck wires inside outlet box (D).
MOUNTING AND WIRING INSTRUCTIONS
FIXTURE ASSEMBLY INSTRUCTIONS
1. Place back plate (B) over mounting screws (I) (see fig. 1).
2. Secure into place with cap nuts (A).
3. Install lamp(s). Do not exceed recommended wattage.
4. Remove two cap nuts (J) from inside rim of fixture cage (K).
5. Install fixture cover bracket (L) over screws inside cage (K) and secure with cap nuts (J).
6. Place roof (N) over nipple (O) on fixture cover bracket (L) and secure with rubber ring
(R) and finial (P).
7. Secure tail finial (Q) to bottom of fixture cage (K).
8. Turn power back on at circuit box.