User manual

CLEANING THE OVEN

Replacing the oven door

1 Relocate both hinge arms at the same time into the housing on the oven front.

2 Make sure that the location notches on the bottom of the hinge arms are positioned

onto the lower cut-out lip.

3 Close the door partially to make sure that the location notch drops into place.

4 When the hinges are located, open the door fully and make sure that the stirrups are

disengaged.

• Do not immerse the door in water.

• Do not carry the door by the handle.

• Do not use force.

Cleaning the shelves

1 Slide shelves forward until they reach the

front stop.

2 Tilt the shelves up at the front to clear the

side supports.

3 Lift the shelves clear.

4 Wash the shelves in hot soapy water.

5 Reverse the above steps to put shelves

back in.

Removing the shelf supports

1 Grasp the shelf supports at the front.

2 Pull them towards the centre of the oven.

3 To install the shelf supports, first insert

the rear hook into the rear hole.

4 Locate the front peg into the front hole

and push firmly.

Removing the fan cover and

oven light glass

1 Hold fan cover by the two sides.

2 Pull towards you.

3 To replace the fan cover insert the two

tabs at the bottom of the fan cover into

their corresponding holes and then push

the top in firmly.

4 After cleaning the fan, cover must be

replaced.

5 Turn the oven light glass anti-clockwise to

remove it for globe replacement.

CLEANING THE OVEN