Specifications

Section 5: Bench Check
5-7
MSM Auto Sensing PCA
774/774-A Switch
Goof Switch
(S3)
Tamper Switch
Battery Switch
(S2)
Reset Switch
(S1)
Figure 5-3: Alto 818 Switch Locations (Cover Removed)
5.3.2 TERMINAL TEST
This test is used to verify the installation and configuration of the terminal.
1. Observe the terminal monitor; the screen should display system status. (All times and dates
shown are based on factory settings.) If the status is not displayed:
A. Verify that the Alto 818 and the terminal are correctly connected.
B. Verify that the terminal communications parameters are correctly set as described in
Section 5.2.
2. Press the Enter key. The screen displays:
YOUR PASSWORD?
3. Type NEW and press Enter. (The password must be entered within 10 seconds after it is
requested.) The screen displays:
HELLO
TYPE HELP FOR A LIST OF COMMANDS
YOUR COMMAND?