Specifications

Section 5: Bench Check
5-11
5. At the command prompt, type STATUS (STA) to display the status of the digital reader on
the door defined above. The correct display for a sensor on door 1, a DigiReader on door
3 and VIP2 on door 2 are highlighted on the sample STATUS screen, Figure 5-6.
The DigiReader LED should be illuminated.
VIP2
1. From the command prompt, type DOOR (DO) and press Enter.
2. Enter the door number which corresponds to the address of the VIP and press Enter.
3. Type 19 and press Enter. The screen will display:
19. VIP ENABLE (Y/N): N?
4. Type Y and press Enter.
5. Press the Escape key to exit the command.
6. At the command prompt, type STATUS (STA) to display the status of the VIP2 on the door
defined above. The correct display for a sensor on door 1, a DigiReader on door 3 and VIP2
on door 2 are highlighted on the sample STATUS screen, Figure 5-5
The middle VIP2 LED should be illuminated.
| Building Mode | Tamper | Power | Alarm |
|-------O-------|----A---|-------|-------|
|######| Door | Coax | SnSr | Reader | VIP | MSM | MP1 | MP2 | MP3 | MP4 |
|--#1--|------|------|------|----NE---|----NE---|-----|-----|-----|-----|-----|
|--#2--|------|------|--NE--|----NE---|---------|--NE-|-----|-----|-----|-----|
|--#3--|------|------|--NE--|---------|----NE---|--NE-|-----|-----|-----|-----|
|--#4--|------|------|--NE--|----NE---|----NE---|--NE-|-----|-----|-----|-----|
|--#5--|------|------|--NE--|----NE---|----NE---|--NE-|-----|-----|-----|-----|
|--#6--|------|------|--NE--|----NE---|----NE---|--NE-|-----|-----|-----|-----|
|--#7--|------|------|--NE--|----NE---|----NE---|--NE-|-----|-----|-----|-----|
|--#8--|------|------|--NE--|----NE---|----NE---|--NE-|-----|-----|-----|-----|
O = Open L = Limited C = Closed
F = Fail S = Shunted A = Active U = Normal Unlock NE = Not Enabled
HO = Held Open Fo = Forced Open TS = Tamper Shunted TA = Tamper Active
Figure 5-6: STATUS Display  Sensor, DigiReader and VIP2