Specifications

Alto 818 Installation and Operation
6-8 P/N 66109074001 Rev. D
Access code 1 is preprogrammed at the factory to be applicable to all controlled doors, 24 hours
a day, 7 days a week, including holidays. It is useful when the system is first installed on site,
before the database is set up. The access doors and times for code 1 can be changed during
or after database setup to suit the requirements of the installation.
The remaining access codes (2-120) have no preprogrammed time intervals or days for any
door.
To enter access code data, proceed as follows:
1. At the command prompt, type ACC and press Enter. The screen displays:
ACCESS CODE (1-120)?
2. Accept this code number or type a different number and press Enter. The screen displays:
DOOR (1-8)?
3. Enter the desired door number or make no entry for door 1. Press Enter. The screen displays
(1)
00:00-00:00
4. Enter the time intervals and days for access to door 1. The time/day prompt is repeated three
times for a total of four time intervals. Press Enter after the fourth interval. The screen
displays:
(2)
00:00-24:00 ?
5. Continue to enter time intervals and days for the remaining doors, 2 through 8, as required.
6.3.2 BYE
The BYE command is used by an operator to log off the system and to return to the operation
mode. A valid password must be entered to again enter the command mode.
6.3.3 CLOSE
This command is applicable only if the Alto 818 system is set up to use building modes, and open,
closed and station sensors have been defined with the DOOR command (see Section 6.3.5).
Entering the CLOSE command places the building in the building-closed mode.