Specifications

Section 6: Commands
6-15
When Y is entered at the prompt, the key reader will remain active and the unlock time will
automatically drop to 1 second while the door is open. As long as keys are presented to the
sensor within the DOOR OPEN TOO LONG time selected in field 14, no log message will
be generated.
It is recommended that time-and-attendance doors be equipped with an audible and/or visual
device that activates each time the door is unlocked. Then, if the unlock time is dropped to
1 second, the key holders can tell that their keys has been read as they enter or exit. Such
devices will also assist security personnel in monitoring the door.
The default for this prompt is N. Enable as required and press Enter. The screen displays:
19. VIP ENABLE (Y/N): Y?
28. A VIP2 used on a door must be enabled by a Y response to this prompt; the default is N.
Enable or disable the VIP2 for this door as required. When enabled additional parameters
may be set; the screen displays:
19A. VIP REQUIRED WHEN BUILDING IS:
OPEN (Y/N): N?
29. When building modes are used, use this field to specify during which modes the VIP2 is
required. Select Y or N for this and the two modes to follow. The screen displays:
LIMITED (Y/N): N?
CLOSED (Y/N): N?
AND DURING TIMES AND DAYS
00:00-24:00 MON TUE WED THU FRI SAT HOL
30. Required times for the VIP can be specified by time and day instead of or in addition to the
modes described above. Four time intervals may be entered. Notice the default for the first
interval makes the VIP2 required 24 hours a day, every day. Make time and day entries. The
screen displays:
19B. VIP FAILURE REPORT (0-32): 1?
31. Type a report number to be associated with a VIP2 failure for the door being configured.
Press Enter. The screen displays:
20. DEVICE TAMPER REPORT (0-32): 1?
32. Type a report number for the activation of the VIP tamper switch. After pressing Enter, the
command prompt is displayed.